In automatic cnc pipe end forming machines During operation, all components can be maintained under harsh environmental conditions (such as rain), improper operation and misoperation, and overload. All systems of the pipe bending machine are suitable for operation in the environment of ±40℃ and 0 ~ 100% humidity. The pipe bending machine is suitable for local use at an altitude of 0 ~ 3000m. The pipe bending machine should select a suitable workplace before working. The quality of a fully automatic machine is very important for the quality of the subsequent production, so how should the quality be identified? Table and bending machine experts believe that you can start from several aspects:

1. Mold base hardness and mold hardness are also the key to the normal use of the equipment in the future. When the mold hardness is lower than Rockwell HRC60 mold hardness is lower than Rockwell HRC50, it will affect the clamping quality of the hose.

2. Measure the main parameters of the equipment: let the equipment be in the state of air transport, touch each mold block with your hand, and the feel should not shake, otherwise it is regarded as unqualified products.

3. Install the equipment on the mold, buckle a sample joint, and measure the buckle joint with a caliper or micrometer. The circularity and taper should be buckle within 0.1mm, which is considered excellent.

4.* After that, check the equipartition of the eight-petal mold base of the equipment and the flatness of the mold. Good equipment will do special control adjustment for these two items, and some poor quality equipment does not control the above two parameters.

Automatic quality is good, in the production process, we also need to pay attention to a problem is the stability of the bending machine processing, in summary, including two aspects, one is its contact degree, the second is the pressure gauge. Only these two aspects meet the requirements, in order to prevent the machine tool and the mold of the bending machine from being damaged, and ensure the quality requirements of the bending workpiece. The pipe bender mold on the pipe bender is divided into upper and lower parts. The overlap is the overlap of the upper and lower molds. In addition, it is also divided into longitudinal coincidence and horizontal coincidence, in the longitudinal coincidence, pay attention to the gap between the two, not too large and not too small. Therefore, when adjusting the gap, it is also necessary to pay attention to the adjustment of the pressure gauge.

automatic cnc pipe end forming machines https://www.john-sheng.com/CNC-Tube-End-forming